|
|
| • Supermicro X8DTT-F/IBXF/IBQF |
• Dual LGA1366 Sockets
• Supports up to two Intel® Xeon® Processors 5600/5500 series |
| • Intel® 5520 + Intel® ICH10R + IOH-36D chipset
|
| • 4.8GT/s, 5.86GT/s and 6.4GT/s
|
• 12 240-pin DIMM sockets
• Supports up to 48 GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory
• Supports up to 24 GB 1333 / 1066 / 800MHz DDR3 Unbuffered memory
• Memory Mirroring supported
• Corrects single-bit errors
• Detects double-bit errors (using ECC memory)
• Supports Intel® x4 and x8 Single Device Data Correction (SDDC) |
|
• 1 PCI-Express 2.0 x16 (Low-Profile) |
• Six SATA ports (3 Gbps) via ICH10R
• Supports SW RAID 0, 1, 5, 10 (Windows)
• Supports SW RAID 0, 1, 10 (Linux) |
• Mellanox ConnectX DDR Infiniband 20Gbps Controller w/ QSFP connector (X8DTT-IBXF)
• Mellanox ConnectX QDR Infiniband 40Gbps Controller w/ QSFP connector (X8DTT-IBQF) |
• IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
• Winbond® WPCM450 BMC |
• Dual Gigabit LAN with Intel® 82576 Ethernet controller
• Intel® I/OAT 3 support for fast, scaleable, and reliable networking
• VMDq support for better performance of virtualization
• 1x Realtek RTL8201N PHY (dedicated IPMI) |
|
• Matrox G200eW graphics controller with 8 MB DDR2 memory |
|
• Winbond 83527HF chip |
SATA
• Six SATA ports
• Six SATA hard drives supported
LAN
• 2x RJ45 LAN ports
• 1x RJ45 Dedicated IPMI LAN port
USB
• 2 rear + 1 header (2 Ports)
• Total 4 USB 2.0 Compliant
VGA
• 1x VGA Port
Serial Port
• 1 Fast UART 16550 serial port
Infiniband
• 1 External QSFP Infiniband Connector (IBQF/IBXF Model) |
Software
• IPMI 2.0 with KVM support
• NMI
• Watch Dog
• SuperDoctor III
Power Configurations
• ACPI Power Management
• Main Switch Override Mechansim
• Power-on mode for AC power recovery |
CPU
• Monitors for CPU Cores,+1.5V, +3.3V, +5V, +12V, +5 Stdby, +3.3 Stdby, VBAT, Memory Voltages
• CPU Core 6-Phase-switching voltage regulator
Fans
• Total of four 4-pin PWM fans
• 4x fans with tachometer monitoring
• Status monitor for speed control
• Status monitor for on/off control
• Low noise fan speed control
Temperature
• Monitoring for CPU and chassis environment
• CPU thermal trip support
• Thermal Control for 4x Fan Connectors
• PSU I2C temperature sensing logic
• Thermal Monitor 2 (TM2) support
• PECI
LED
• Power Fail / Overheat LED
• Suspend-state Indicator LED
• UID LED
Other Features
• SDDC Support |
• 32Mb SPI Flash EEPROM with AMI® BIOS
• Plug and Play (PnP)
• PCI 2.2
• ACPI up to 3.0
• USB Keyboard support |
Supermicro 6016TT-TF/IBXF/IBQF
Form Factor
• 1U Rack
Drive Bays
• 4 x 3.5" hot-swap SATA drive bays (2 for each node)
System Cooling
• 2x sets of 3 x 4cm heavy duty PWM fans w/optimal fan speed control
Power Supply
• 1200W high-efficiency Gold Level cold-swap power supply w/PMbus
Dimensions (H x W x D)
• 1.7” ( 43mm) x 17.2" (437mm) x 27.75" (704mm)
Rear I/O
• 2x Rear I/O Ports Including 2 USB, VGA, COM, 2 LAN Ports, InfiniBand w/ QSFP Interface (IBQF/IBXF Model)
Front Panel Features
• 2x sets of Power status, HDD activity, 2x network activity and system overheat LEDs
• 2x sets of independent power on/off & reset buttons
Supermicro 1026TT-TF/IBXF/IBQF
Form Factor
• 1U Rack
Drive Bays
• 8 x 2.5" hot-swap SATA drive bays (4 for each node)
System Cooling
• 2x sets of 3 x 4cm heavy duty PWM fans w/optimal fan speed control
Power Supply
• 1200W high-efficiency Gold Level cold-swap power supply w/PMbus
Dimensions (H x W x D)
• 1.7” ( 43mm) x 17.2" (437mm) x 27.75" (704mm)
Rear I/O
• 2x Rear I/O Ports Including 2 USB, VGA, COM, 2 LAN Ports, InfiniBand w/ QSFP Interface (IBQF/IBXF Model)
Front Panel Features
• 2x sets of Power status, HDD activity, 2x network activity and system overheat LEDs
• 2x sets of independent power on/off & reset buttons |